Teams & SP63

[mandurahbridge]

I was very happy to read about the enhancement that allows Bridgemates to be used in 3 way matches.
In experimenting with setting up movements I have run into a problem if I try to vary the tables assignments that are provided automatically so that I can run a Round Robin rather than use auto draw for subsequent rounds.
For example with a 9 table, 8 round event with the 3 way match played over two rounds the table assignment automatically produced for round one is (with the tables = teams option)
1v4
2-5
3-6
7v8
9v9
9v7
If I change the first three tables to say
1v3
5v4
6v2 , complete the set up and then proceed to set up the next round manually the default tables are
1v4
2-5
3-6
7v8
9v9
9v7 As this is how I want the second round I complete the set up and proceed to set up round 3 and this is where I run into a problem because I cannot change the last 3 table assignments to suit what I need ie
2v3
7v1
8v4
5v9
6v9
9v5 because the last pair cannot be changed from the default 9v7

I hope the above makes sense - could you advise what I am doing incorrectly?

Thanks, Neville

[ianmac]

First there is a problem when using tables=teams; that is being addressed.
I will try to work out your manual assignment (e.g 9v9?) but if played over two rounds then there is no 3-way in the second round.

[mandurahbridge]

Thanks Ian

I figured that was the case but could not work out how to not have them in the table assignment list.

I will wait on your further advice - it would be very helpful if can work out the table assigments for the Round Robins.

Regards

Neville

[ianmac]

The latest service pack (SP64) addresses these problems.
see
http://www.asecomputing.com/forums/showthread.php?t=709
and
http://www.asecomputing.com/forums/showthread.php?t=710
for more details.